A Step-by-Step Guide to Installing a New Toilet

 Materials and Tools Needed:

  • Putty Knife
  • Adjustable Wrench
  • Level
  • Tape Measure
  • Sponge

 

First step to installing a new toilet is to remove your old one! The angle stop located directly under the toilet tank with a supply line attached to it. Make sure this supply line is shut off. You spin your angle stop knob to the right to tighten and then remove the supply line attached to the toilet tank you do this with a pair of channel locks spin to loosen.

 

Once the angle stop is shut off the next step is to remove all water from the toilet and tank. Flush the toilet until there is nothing left to flush. Then proceed to the bolts at the bottom of toilet. There is one on each side. They might even be covered with white caps. You are to take a crescent wrench to the bolts and loosen them till you can remove them. Once the bolts are removed proceed to pull the toilet up and off the bolts attached to closet collar (a part the toilet gets tightened to). Remove toilet to discharge.

 

Installing a new toilet

 

 

Once the toilet is removed check the collar and remove old wax ring(s), please use gloves because it is messy and dirty. Remove old toilet bolts install the new toilet bolts the same way you took them out.

 

Once the bolts are in place, place new jumbo wax ring on closet collar, directly in the middle. Pick up newly assembled toilet and place on top of toilet bolts and then sit on toilet till it works its way into the wax ring making a tight air free connection. Tighten the new bolts with proper washers. But do not tighten to tight because you can crack the porcelain.

 

Place the caps to cover bolts. You then need to reconnect the toilet supply line. Tighten tight to angle stop and hands tighten to toilet tank.

 

Your toilet is designed to use either 1.4 or 1.6 gallons of water per flush. Adjust the flush volume in the tank by adjusting the water level to the appropriate water line, the water lines are marked on the flush valve. To raise the water level pinch the C-clip and slide it up the float rod.Once complete turn on angle stop and enjoy your new toilet.

 

There is no need to hire a plumber or sewer expert to install a new toilet, but if you feel the need to have it done professionally to assure no mistakes are made, we are more than willing to help!

The North Coast Family

Leave a Reply

Copyright North Coast Sewer & Drainage 2012-2013 . All Rights Reserved